Allen Bradley Motor Control Center & Disconnect
This 24" X 10" wide X 6" Deep enclosure is set up for 575VAC 3 Ph- 5HP motor, the enclosure contains the following:
Allen Bradley Size 1 - 3PH starter contactor A-B Cat.# 509-BO-18A-B
27A CONT. Max - 600vac Max.
Starter coil = 110-120VAC - Heaters=W45 (5.2) motor amps
3 Ph Fuses = HRC- 11- CGL & CIA 20 amp fuses - IR 2000ka
1PH control fuse = Tron KAA5
Control voltage supplied by a Hammond MH25AJ step down transformer-600VAC to 120 vac - 25VA - 60hz 55C rise
Also included is a Cuttler Hammer stop/start remote P.B. enclosure.
This unit was built as a test unit for testing small conveyor systems once in a while, typically used about 6 to 12 times a year for about an hour each time. It has not been installed or used for permanent installation, so there is very little "electrical wear. The start/stop PB box is currently wired up, so that the contactor can be tested by you.
Finally retired from HD Electrical, and do not need it any more. My shop is now 220VAC single ph.
Feel free to ask any questions, and please note; all sales are cash only "not gonna get stiffed again"!!
|Last hour||Last 24 hours||All|